Manual plasma cutting machines

SVAROG 105 PLASMA

SVAROG 105 PLASMA - is a manual plasma cutting machine. The cutter is designed for cutting high quality materials up to 42 mm thick carbon steel. The productive cut of carbon steel can be 35 mm thick. At lower requirements for cut quality, the material thickness can be cut up to 55 mm. Equipped with a proportional valve that allows you to precisely set the required gas operating pressure and the pressure values appear on the display.

CUTi 35

Kjellberg CUTi 35 - Manual plasma cutting inverter can be used for cutting electrically conductive materials. - carbon steel, stainless, aluminum and copper, up to 12 mm thick. The device is equipped with PFC (power factor correction) guarantees maximum power consumption from a single-phase 230 V network.

CUTi 35C

The Kjellberg CUTi 35C is a manual plasma cutting source with an integrated compressor. The machine is designed for metal cutting, equipped with an integrated compressor up to 6mm, with an external compressed air supply of 10mm. 230VAC single-phase power connection and device weight of 12.5 kg guarantee the highest mobility.

PERUN 40 PLASMA PFC

PERUN 40 PLASMA PFC - Plasma power supply. Manual plasma cutter for cutting metal material with compressed air. It is possible to ceiling carbon steel up to 15 mm in very good quality. IGBT inverter, machine is equipped with a power factor corrector PFC, which allows the unit to operate stably at supply current fluctuations from 115 to 265 V.

CutMaster 25

CutMaster 25 Industrial hand plasma cutting machine is the most productive and most powerful. The unit provides sufficient power for cutting metal with thickness up to 30 mm.

CutMaster 35

CutMaster 35 Heavy industrial hand plasma cutting machine is the most productive and most powerful. The unit provides sufficient power for cutting metal with thickness up to 40 mm.

CutMaster 40

Plasma cutting unit CutMaster 40 is the most productive and most powerful. The unit provides sufficient power for cutting metal with thickness up to 55 mm.

PEGAS 101 PLASMA

With PEGAS 101 PLASMA cutting machine is possible to productively cut carbon steel up to 25 mm material thickness, and to cut up to 40 mm in a good quality (but slower) and simply to separate material of 50 mm thickness, in manual cutting mode. IGBT inverter. This plasma power source is small in dimensions, big in power. Cutter is designed for use in heavy industrial work. Automation system interface on request.

PEGAS 121 PLASMA

With PEGAS 121 PLASMA cutting machine it is possible to productively cut carbon steel up to 25 mm material thickness, and to cut up to 50 mm in a good quality (but slower) and simply to separate material of 60 mm thickness, in manual cutting mode. IGBT inverter. This plasma power source is small in dimensions, big in power. Cutter is designed for use in heavy industrial work. Automation system interface on request.